SetDecoration Command
- SetDecoration( <Object>, <Number> )
-
Sets the decoration of the given object (see also the Style tab in the Properties window of the object). The object must be an angle, a segment or a "fillable object". The second argument in the command is the numeric code of the decoration / fill-style, as described in the following table.
| Value | Segment decoration | Angle decoration | Fill-style |
|---|---|---|---|
0 |
Remove decoration |
Remove decoration |
Solid fill |
1 |
One tick |
Two arcs |
Hatched |
2 |
Two ticks |
Three arcs |
Cross-hatched |
3 |
Three ticks |
One tick |
Chessboard |
4 |
One arrow |
Two ticks |
Dotted |
5 |
Two arrows |
Three ticks |
Honeycomb |
6 |
Three arrows |
Clockwise arrow |
Brick |
7 |
(None) |
Anticlockwise arrow |
Weave pattern |
- SetDecoration(<Segment>, <Number>, <Number>)
-
Sets the aspect of the line start and end of a segment. In order to view the decoration, it’s necessary to hide the two points that define the vertices of the segment. The segment decoration can also be set in the Style tab of the Properties window of the segment. The first number used as command parameter defines the style of the line segment start, and the second number sets the style of the line segment end, as described in the following table.
| Value | Decoration |
|---|---|
0 |
No decoration |
1 |
vertical bar |
2 |
empty square |
3 |
filled square |
4 |
arrow |
5 |
filled arrow |
6 |
empty dot |
7 |
filled dot |